Floating Point Overflow - processing Lithology Per

[terryyoung]

I can open my data file and compile it with no problems.

I set up a batch compile file, when I execute the batch compile I get

an error: "Floating Point Overflow - processing Lithology Percent"

This error does not occur when using the same files as the batch compile

but doing it manually?

Thanks

Terry W. Young

[Mitch]

Hi Terry,

there's not much help I can offer on LogPlot 2001 but if you send your files (LDF, DAT and batch file) to support@rockware.com we'll take a look,

[terryyoung]

Hi Terry,

there's not much help I can offer on LogPlot 2001 but if you send your files (LDF, DAT and batch file) to support@rockware.com we'll take a look,

<{POST_SNAPBACK}>

[terryyoung]

<{POST_SNAPBACK}>

I will send them tonight from the rig.

Thanks

Terry

[terryyoung]

Hi Terry,

there's not much help I can offer on LogPlot 2001 but if you send your files (LDF, DAT and batch file) to support@rockware.com we'll take a look,

<{POST_SNAPBACK}>

[terryyoung]

<{POST_SNAPBACK}>

From Mitch - Solution to problem

Found the problem and it has to do with the placeholders ("?") that were

being used in LP2001. The data editor handles them properly but the

batch compiler doesn't in the Percent section. The fix in 2001 is to

replace the ?'s with 0's in the Percent table.