Evyatar Cohen Posted December 14, 2015 Share Posted December 14, 2015 hi, I've made a simulation with different permeability (Perm. Mod in Set Cell Data) in every element. after the simulation had finished the output file was a bit different. in the ELEM section the property DL was replaced with PER.MOD. but in the 3D results the DL is shown. i'd like to know where i can find the DL values. Best regards, Evyatar. Link to comment Share on other sites More sharing options...
Alison Posted December 16, 2015 Share Posted December 16, 2015 Could you tell me which simulator (TOUGH2, TOUGHREACT, etc.) and which EOS module you are using? Each fluid property module is slightly different, so it would be helpful if we could try to reproduce the problem ourselves. If you would like to send us your SIM file, that would probably be helpful as well. You can send it to Alison @ rockware.com. Best Regards, Alison Link to comment Share on other sites More sharing options...
Evyatar Cohen Posted December 17, 2015 Author Share Posted December 17, 2015 hi Alison, i'm using TOUGH2 simulator and ECO2N module. also i'm sending you the file. Best Regards, Evyatar. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now