Jump to content
RockWare Support Forum

How to Bring Modeled surface up to ground surface?


dogsonice
 Share

Recommended Posts

Hello all,

I'm working with a 3-D strat model with a varied ground surface and not a lot of wells to correlated with. In some areas of the model, the top of the uppermost layer is not coming all the way up to the ground surface leaving a gap between the top layer and ground surface (I'm constraining the model top with a surface grid). Is there a way to bring the top of the uppermost layer up to ground surface with Rockworks, or would I have to put in "dummy" points to do this?

Thanks

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...