Jump to content
RockWare Support Forum
Sign in to follow this  

unintended vertical offsets at cross-section bends

Recommended Posts

I have unintended vertical offsets at the bends in my cross-sections. This seems to happen regardless of the angle of the bend, or whether or not there's a bore-hole log at the bend. The offset is not consistent between different stratigraphic units or between bends.

Why might I be getting these offsets?

How do I avoid this problem?

I am using the Modeled Section under the Stratigraphy menu (RW 2004). There's an example of my problem in the tutorial for this tool (last image, left circle).

Thanks for any help.

-- Michael

Share this post

Link to post
Share on other sites

Hi Michael,

The discontinuities are caused when you request smoothing of the grid surfaces. If you set the Smoothing Passes to zero, you'll get better alignment.

Molly Mayfield

RockWare Inc

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Create New...