Jump to content
RockWare Support Forum
Sign in to follow this  
mnapolitan

Reference point for waterlevel measurements

Recommended Posts

I assume that the depth to water is referenced to the elevation that is input into the location tab. This works if you have a borehole with no casing for reference, or if you convert the depth from top of casing to ground surface. It would be better to have an addtional column in the location tab to have casing elevation for groundwater measurements.

Share this post


Link to post
Share on other sites

You are correct, right now, the water level measurements are based on the top elevation of the hole, referenced in the Locations table. We have submitted a request for this to change in the next version of RockWorks. If you have any additional suggestions, please feel free to email me directly at [email protected]

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...