Jump to content
RockWare Support Forum

Adding Vertical 3D Panels to Lithology Fence Diagram?


Derek Clark
 Share

Recommended Posts

I have a lithology fence diagram that I would like to update with vertical panels (snipped images of geophysical survey results) but can't figure out how to do it. I was able to create a separate file with the images using Utilities -> Imagery -> Vertical (Images -> Vertical 3D Panels). I tried to simply open both in GoogleEarth but GoogleEarth gives an error that it can't read the image files (.dae). Any help would be appreciated!

Link to comment
Share on other sites

Hi Derek,

 

The following comments refer to numbered items within the attached image.

 

1. The Graphics / Images / Google Earth / Vertical - Two Points Advanced program will position images as vertical panels within Google Earth.

2. To use this program, you'll need to create a datasheet with the coordinates for the lower-left and upper-right corners of each image.

3. Specify which column contains the relevant data.  Note the Vertical Position tab.  This allows you to vertically exaggerate and vertically offset the panels.

4. The panels will be displayed in Google Earth.

 

If you get stuck, please send an email to jim@rockware.com.

 

Best regards,

 

Jim Reed.

Temp.png

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...