2D log design

[steckler]

Hello, 

I would like to know if it is possible to create several "2D log design" for the same 2D profile.

Ex: on a geotechnical profile, I have to draw:

* 5 BH with SPT results 

* 7 CPTS with qc curve

* 6 Pressumeter BH with pl and Em curves

If I create a single "2D log design" with all the columns (litho, strati, SPT, qc, pl, Em), I will get plenty of emplty columns in the profile.

Thank you very much for your help

Best regards

Mathieu

[Paul Crossett]

Mathieu,

 

At this time we do not have a way to select different data for individual logs within a profile, the only option currently is a one log type for all where you select the data that will be presented for each log in the 2D striplog designer.

[Alison]

One option might be to create three different profiles with different boreholes enabled and different 2D log setups (using the example same profile line), and then appending the Rw2D files together.  This would be a bit tedious, but could probably be accomplished with a playlist.