Jump to content
RockWare Support Forum

Creating an environmental model with straight boundaries


tvdw

Recommended Posts

For a project, we have performed environmentally research and based on this research polygons are determined. These polygons represent an environmental code of that area. I would like to make from all these polygons a 3D model. I have added all the points on the polygons as boreholes in RockWorks and added the environmental codes as lithology. The condition for this 3D model is that the boundaries must be straight down and without interpolating between different points/polygons. Do you have an idea if I am able to do this in RockWorks? And if so, what settings must I use? Thank you already in advance.

Link to comment
Share on other sites

Dear Tom,

Is the polygon file input a text file with the points and coordinates? Do you have an example how this will look like? I have the points on the polygons with upper and lower elevation with the environmental code. But then I will make for each polygon a different file?

Thank you already in advance.

Regards,

 

Thaïsa

Link to comment
Share on other sites

Dear Tom,
 

An additional question, what will the cut off distance do? And which value is it best to set keeping in mind that the boundaries must be straight down and no interpolation can happen?

 

Regards,

 

Thaïsa

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...