Jump to content
RockWare Support Forum
Allison

Showing deviated logs in a profile section

Recommended Posts

Trying to create a 2-dimensional profile of logs that are not all vertical. Borehole deviations look correct at a 1x vertical exaggeration but then look "smeared" after choosing a higher VE.

Can't figure out why it's doing this.

Attached a pdf of the 2D section at a VE of 10x.

Rockplot - test.pdf

2018-12-04_15-36-24-613.png

Share this post


Link to post
Share on other sites

Hi Allison,

 

The logs are "smeared" due to the vertical exaggeration set to 10x. The vertical difference between the right side of the log and the left side of the log is increased by a factor of 10x with this setting, causing angles to approach vertical. 

 

 

 

Regards,

Tom B

RockWare Inc

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×