Jump to content
RockWare Support Forum

Recommended Posts

When plotting correlation lines for Stratigraphy, if the corresponding well log does not have a matching geology unit the correlation line forms a point and plots back to the originating log.

See the attached graphic for an example of this behavior.

Is there a setting or method to tell rockworks to not draw this line when no corresponding segment exists in the adjacent log?



Link to post
Share on other sites

Hi Pat,


Turn off the option to "Create Pinchouts Within Linear Correlations" on the right side of the menu for Striplogs | 2D | Section pane to remove the pinchouts.



Tom B

RockWare Inc




Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...