rudyabo Posted June 27, 2017 Share Posted June 27, 2017 Hi RockWare Forum members and support team, after manual contraction of a 3D Stratigraphic model (Advanced Stratigraphic modeling), it is common to see cutting edges around the boundaries of each layer. What is the best way to smooth those edges and minimize the difference between layers? I usually use Grid Editing tool, but it is rather difficult and tedious in some complex cases particularly in higher resolution models. Any suggestions or protocol to follow solving such issue? all the best, Rudy Link to comment Share on other sites More sharing options...
rudyabo Posted June 28, 2017 Author Share Posted June 28, 2017 Hi Tom, I guess in this case I have to generate each surface again (Grid --> Math), since the residual between each two contacts will be larger. Regards, Rudy A Link to comment Share on other sites More sharing options...
rudyabo Posted June 28, 2017 Author Share Posted June 28, 2017 Hi Tom, that sounds good. thanks! I will try. Regards, Rudy Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now