Jump to content
RockWare Support Forum

Measuring Bearing and Inclination on a profile


JoshZA
 Share

Recommended Posts

Short of doing a manual calculation for inclination based on z's is it possible to measure this off a profile?  There is no "measure inclination tool" (and obviously this would need to take into account the vertical exaggeration in your profile plot).  If I try to use the bearing tool on a profile this is meaningless as it gives you an angle which should be the orientation of the profile but isn't and is also not the dip/inclination of anything you measure.

 

I'm trying to use this as a quick method in the planning of follow-up boreholes.

 

Thanks.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...