JoshZA 0 Report post Posted February 13, 2017 Short of doing a manual calculation for inclination based on z's is it possible to measure this off a profile? There is no "measure inclination tool" (and obviously this would need to take into account the vertical exaggeration in your profile plot). If I try to use the bearing tool on a profile this is meaningless as it gives you an angle which should be the orientation of the profile but isn't and is also not the dip/inclination of anything you measure. I'm trying to use this as a quick method in the planning of follow-up boreholes. Thanks. Share this post Link to post Share on other sites
JoshZA 0 Report post Posted February 13, 2017 Think I may have answered this myself, left is 270, right 90 and straight down 180. VE makes angles look odd. Share this post Link to post Share on other sites