Problem to generate one long PNG with LP8

[Christian 0]

Good morning,

I am experiencing some issue to Export log as one long PNG.

I am using the same setting used on LP7: scale 2.5 units per cm // Units per page 1 // 90 dpi, meanwhile with LP7 I was able to create a png image of the entire log (3750 m), with LP8 I got this message: The output size (1138 x 359539) is too large. Increase the scale or reduce the Pixels PerInch (DPI).

Even with 10 dpi I can not create any long PNG.

Thanks,

Christian

[Mitch 0]

Hi Christian,

we're going to release a 64 bit version of LogPlot8 this week which should resolve the memory issues you're having. If you need to get something out right away you should try restarting LogPlot. Windows programs can have problems with fragmented memory and then can't find a memory block big enough for certain operations.

MItch

[Christian 0]

Ok Mitch, I will wait for the 64 bit version.

Thanks,

Christian

[Mitch 0]

The 64 bit version is now available. You will need a new unlocking code but there is no charge. We also recommend uninstalling the 32 bit version to avoid confusion.

[Christian 0]

Mitch,

LP8 64 bit version it's installed, but unfortunately still not able to produce a proper PNG

The output size (967 x 299131) is too large. Increase the scale or reduce the Pixels PerInch (DPI).

Same type of laptop, with LP7 it's not giving any problem to generate one single PNG.

Any suggestion?

[Mitch 0]

Hi Christian,

I found some problems with the very long exports and hope to have a new version available soon.

[Christian 0]

Thanks Mitch!

[Mitch 0]

Hi Christian,

sorry it took so long but the versions (32+64) are up. I redesigned the export dialog to make it easier to use.

[Christian 0]

Hi Mitch,

just downloaded and tested, no problem to generate my long PNG.

Excellent job and best wishes for 2017.

[Mitch 0]

Thanks for hanging in there.