Jump to content
RockWare Support Forum

Plotting lables in RW3D

Recommended Posts


I am plotting lables at the endpoint of my boreholes in RW3D (takeing the endpoint of each well and plotting it in RW3D with the asociated label). I would like the label to be centered with respect to the borehole itself and offset a little bit below it. I saw the options for vertical offset and %offset but nothing related to horizontal offset. I have played with the vertical offset and that gets my lables far enough below the borehole trace and the % offset seems to move the label in the horizontal plane but I am not sure how it works or if there is an easier way to center lables at the end of borehole traces in RW3D.

Link to post
Share on other sites

Unfortunately OpenGL provides very poor tools for text placement and sizing. Your only alternative is to use the offsets however this won't provide consistent results from one diagram to another.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...