mnapolitan 0 Posted July 14, 2014 Is the Z elevation for the end of the 3D tube the invert, middle, or the top of the tube? THe documentation is not clear as to what the z elevation should be. Share this post Link to post Share on other sites
Molly 0 Posted August 11, 2014 Hi MNapolitan, Sorry for the delay in replying - just saw this post! The X1Y1Z1, X2Y2Z2 coordinates will define the center points of the tubes. The Radius will define the extents of the tubes outward from these points. Molly Mayfield RockWare Inc. Share this post Link to post Share on other sites
