I-Data model

[rudyabo 0]

Dear all,

please anyone has a solution for the problem shown in the attached screenshot.

after running the model there are no data the Interior areas along the lake boundary! the objective was to clip the model to the boundary polygon using filter to polygon option of the solid model.

any suggestion would be appreciated

thanks

Rudy

[TomB 0]

Hi Rudy,

Use smaller cells when creating your model to provide better resolution. Specify the cell size in the Output (Model) Dimensions at the bottom of the RockWorks 16 main window.

Thanks,

Tom B

RockWare Inc

(Note: changed references to I-Data models. - TB)

[rudyabo 0]

Hi Tom,

thanks a lot for you suggestion, I will try this option and tell you about the result.

regards,

rudy

[rudyabo 0]

Hi Tom,

i tried to increse the grid resolution from 150x150 m to 100x100, i got same result.. (running a model with 100x100 resolution take time 3 to 4 hours)

would you suggest another solution?

thanks

[TomB 0]

You may want to check your modeling settings to make sure that you do not have a distance filter set.

If that doesn't work, backup your database to a ZIP file, and upload your data to http://rockware.com/upload/ or e-mail to support (at) rockware.com. I'll be happy to take a look.

Thanks,

Tom B

RockWare Inc

[rudyabo 0]

Dear Tom,

I checked the model setting and distance filter already disabled.

I am really appreciate your support . I uploaded model database (file name: Rockwork.rar) on rockware uploading page

thanks once again,

Rudy

[TomB 0]

Hi Rudy,

I got the file and I'm looking at it now.

Thanks,

Tom B

RockWare

TomB (at) rockware.com

[rudyabo 0]

Thank you very much Tom for your help, the problem has been solved

I would to ask you if possible to calculate I-Data volumetric for the distribution of chemicals in the lake by based on G-data filtering option (e.g. need to calculate the volume of contaminated water with As in the range between 0.5 to 5 ppb in the lake)

thanks,

Rudy

[TomB 0]

Hi Rudy,

If you have a voxel model (instead of an isosurface), right-click on the model name to the left of the graphic display, choose Options, and turn on the options for Filter | Enabled and Show Volume. Change the minimum and maximum values, and the volume amount will also change.

You can also use the Lithology | Volumetrics menu to display the volume in a table.

Thanks,

Tom B

RockWare Inc

TomB at RockWare dot com