Jump to content
RockWare Support Forum

Cross Sections and Stratigraphy Model


Diane Ubiali
 Share

Recommended Posts

Hi,

I would like some help to improve the stratigraphic model that I am developing. The model is composed by basalt layers, the data used in the model are from core boring. Some errors are occurring during the modeling of the layers. The first error(figure 1) is that the sediment layer is covering all the model surface, but this material does not exist in all the parts (it not described in many logs of the core boring)

The second error is that in the margin in geological sections, where the layers converge to the side until the end of the section (figure 2).

I would like to know how I can correct these errors. The method used to obtain this model is inverse distance weighting (IDW), with exponent two and eight points are used to calculate the nodes. Some tools are activated during the interpolation, such as: Declustering, High-Fidelity and Smooth Grid. To create the model are used the following tools: Constrain Model Based on Ground Surface, Plot Logs, Hide Thin Zone.

Thanks

post-10747-0-48985500-1362743587_thumb.png

post-10747-0-71999500-1362743593_thumb.png

Link to comment
Share on other sites

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...