Khasani Posted February 12, 2013 Share Posted February 12, 2013 I just followed the sample problem of ewasg from website. I have checked all steps as instructed. After running the model I got part of the error message like this: INPUT PRIMARY VARIABLES SPECIFIED AT ELEMENT * 1* ARE NOT CONSISTENT: NaCl MASS FRACTION XS = 0.3000000000000E+00 AT T = 0.450000E+00 DEG-C EXCEEDS NaCl SOLUBILITY = 0.2622126146500E+00 INPUT PRIMARY VARIABLES SPECIFIED AT ELEMENT * 2* ARE NOT CONSISTENT: NaCl MASS FRACTION XS = 0.3000000000000E+00 AT T = 0.450000E+00 DEG-C EXCEEDS NaCl SOLUBILITY = 0.2622126146500E+00 What is the cause then? Regards, Khasani Link to comment Share on other sites More sharing options...
Alison Posted February 14, 2013 Share Posted February 14, 2013 This error is basically saying that you can't have NaCL mass fraction this high at this Temperature. If you bump up the initial temperature to 275 degrees, the model should run without a problem. Thanks, Alison Link to comment Share on other sites More sharing options...
Khasani Posted February 19, 2013 Author Share Posted February 19, 2013 I already gave input for the temperature as 275.55 deg C as stated in the tuturials. I inputted the value in Initial Conditions menu. Is there any other menu that I have to go to? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now