Jump to content
RockWare Support Forum
Khasani

EWASG sample problem error

Recommended Posts

I just followed the sample problem of ewasg from website. I have checked all steps as instructed. After running the model I got part of the error message like this:

INPUT PRIMARY VARIABLES SPECIFIED AT ELEMENT * 1* ARE NOT CONSISTENT:
NaCl MASS FRACTION XS = 0.3000000000000E+00 AT T = 0.450000E+00 DEG-C EXCEEDS NaCl SOLUBILITY = 0.2622126146500E+00

INPUT PRIMARY VARIABLES SPECIFIED AT ELEMENT * 2* ARE NOT CONSISTENT:
NaCl MASS FRACTION XS = 0.3000000000000E+00 AT T = 0.450000E+00 DEG-C EXCEEDS NaCl SOLUBILITY = 0.2622126146500E+00

What is the cause then?

Regards,

Khasani

Share this post


Link to post
Share on other sites

This error is basically saying that you can't have NaCL mass fraction this high at this Temperature. If you bump up the initial temperature to 275 degrees, the model should run without a problem.

Thanks,

Alison

Share this post


Link to post
Share on other sites

I already gave input for the temperature as 275.55 deg C as stated in the tuturials. I inputted the value in Initial Conditions menu. Is there any other menu that I have to go to?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×