Tobias Posted October 22, 2012 Share Posted October 22, 2012 Hi, How can I get positive depth when using the orientation mode? The normal depth scale is set to positive depth. Best regards Tobias Link to comment Share on other sites More sharing options...
Molly Posted October 22, 2012 Share Posted October 22, 2012 Hi Tobias, Just set your scalebar to "Absolute Depth" which is the third option in the Survey-Based Style settings. Molly Mayfield RockWare Inc. Link to comment Share on other sites More sharing options...
Tobias Posted October 24, 2012 Author Share Posted October 24, 2012 Hi Molly, Thanks for the reply. I have tried using the abs. depth function, but end up with the wrong depth, since it's not taking the elevation height into account when calculating the depth. Look at the difference at the depth in the figure below. Hope you can help me. Best regards Tobias Gram Link to comment Share on other sites More sharing options...
Tobias Posted October 24, 2012 Author Share Posted October 24, 2012 My link to my figure Link to comment Share on other sites More sharing options...
Molly Posted October 24, 2012 Share Posted October 24, 2012 Hi Tobias, I'm having difficulty seeing where the problem lies since both depth scales appear to be the same, and they are offset the same amount from the elevation scale. Do you have the surface elevation defined in the DAT file's Setup tab? To proceed further with data-specific questions, it would be helpful to communicate via email, and to have access to your log design (.LDFX file) and your data file (.DAT file). Please address this to our support box: support at rockware.com. Thanks, Molly Mayfield RockWare Inc. Link to comment Share on other sites More sharing options...
Tobias Posted October 25, 2012 Author Share Posted October 25, 2012 The depth to the left is measured depth (MD), the middle depth is TVDSS (or elevation) calculated from orientation and to the right abs depth also calc. from orientation. The TVDSS depths are correct, I only want them to be shown as possitive. What to do? Here is some data and log design file plus figure: test2.dat Well-log-design_small.zip Link to comment Share on other sites More sharing options...
Molly Posted October 25, 2012 Share Posted October 25, 2012 Hi Tobias, The middle scale bar is set up to display elevation values, not depths. Since the surface elevation of the well is defined at 133, then at a measured depth of 5655, the elevations will be negative. Molly Mayfield RockWare Inc. Link to comment Share on other sites More sharing options...
Tobias Posted October 25, 2012 Author Share Posted October 25, 2012 Thank you for the reply. What can I do to get the numbers positive? Is'n there a way to display then without the minus sign? /Tobias Link to comment Share on other sites More sharing options...
Molly Posted October 25, 2012 Share Posted October 25, 2012 Hi Tobias, There is no capability of displaying elevations below sea level as positive values in a Logplot scale bar. True vertical depths can be displayed as positive or negative values, but not elevations. Molly Mayfield RockWare Inc. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now