Jump to content
RockWare Support Forum
JosephECM

Changed xyz data, lith model not plotting now?

Recommended Posts

I recently added some new survey data for the borings I was using to create a solid lith model and when I re-ran the model it is no longer plotting anything at all? Any ideas what I might need to do to create the solid model again? Perhaps RW is still using the old point data that's stored in memory, and it needs to be purged before I re-plot the new model?

Share this post


Link to post
Share on other sites

Hi JosephECM,

The cause of problems with a model is often related to the data or the settings you use to create the model. You may want to check your data for any anomalies and to change your lithology model settings to see if that helps to create the model.

Thanks,

Tom B

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×