Jump to content
RockWare Support Forum

designed elevations


Baseema
 Share

Recommended Posts

I created a lithology cross sections along specific designed ramps in an interchange. I plotted the surface profile from a grid based map that i created. I still need to see the designed elevations along the ramp center line "red line" in order to see the cut and fill areas. how can i do that?

Link to comment
Share on other sites

Dear Tom,

i think I didn't explain myself well.

I attached the longitudinal section of ramp-13 (one of the ramps in a designed interchange project. The upper surface is the existing elevations of the ground surface from a based grid map that I created based on .dxf file.

Now I need to add the red line (the designed elevations along the same cross section. You can see clearly what I mean if you take a look on the .dxf file of the longitudinal ramps, (please find Ramp-13 in this file).

I need this in order to see clearly the cut and fill areas on the lithology section.

I hope know you can understand my goal. Thanks in advance

baseema

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...