Jump to content
RockWare Support Forum
kkelso22

Solid model data extraction

Recommended Posts

I'm very new to Rockworks 15, so the answer to this is probably out there, I just havent taken the time to research it yet. I have well data located around an island, but have no data for the island itself. Can I use a shapefile or other data type to tell Rockworks to disregard the extrapolation of data to these areas? Any other suggestions? Thank you very much!

Share this post


Link to post
Share on other sites

1. Import your shape outline of the island into RockPlot2D.

2. Select the outline polygon, right click and select "Save to Polygon Table".

3. Go to the Utilities and select Solid/Filter/Polygon Clip and apply to your solid model.

Share this post


Link to post
Share on other sites

Thanks for replying to my message Mitch. I saw the tool for applying the clipping filter to an already existing model, and suppose it will work. What I was hoping for was an application that would limit the creation of a grid to only areas in which I have data. I would like to create a model with a top surface that better resembles the seafloor. Any Suggestions?

Share this post


Link to post
Share on other sites

What is wrong with the models that you're getting? A picture might help.

If your data distribution is very good you can try limiting the Maximum Number of Points per Voxel in the Fast Inverse Distance Weighting algorithm.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×