Jump to content
RockWare Support Forum
Joe

plotting static water levels

Recommended Posts

Hi:

I'm putting together some cross sections and need to be able to compare changine static water levels for analysis. However, I'm experiencing some difficulty in getting my water surface to plot on the cross section. I've gone through the 2D Striplog Designer and everything seems to be in order; I've modeled the water level as a single surface, with the distance to the top of the surface the same as the distance to base. Ultimately, I get no level and no symbology showing up on the plot. Any ideas?

Share this post


Link to post
Share on other sites

Hi Joe,

Assuming you have the date filters set up for the correct date or date range, then I think the problem is the depth-to-top = depth-to-base in the Water Levels table. If you set the aquifer to even 0.1 foot thickness, the symbol should be plotted.

Molly Mayfield

RockWare Inc.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×