Jump to content
RockWare Support Forum
Ross McCartney

Modelling injection/recovery in X1t/X2t

Recommended Posts

Hi Ross:

Sure- in X2t, choose Config - Second Reaction Interval. Then in Config - Wells, add a well, and you'll notice that you can specify two injection rates. Set the first one to be your injection (positive rate) and the second to be your recovery (negative rate).

Be sure to set the Time for both intervals in the Initial pane.

Hope that helps,

Tom Meuzelaar

RockWare, Inc.

Share this post

Link to post
Share on other sites