Jump to content
RockWare Support Forum
Craig SS

Polygon Filter

Recommended Posts

Hi TX,

if you're using RockWorks 15 open the Polygon Table and from the toolbar select Plot. Continue to produce a RockPlot2D image of your polygon. Next select Utilities|Clip - Based on Coordinates and enter your project coordinates which will create a new RockPlot2D image of your clipped polygon. Select the polygon and right and select Save To Polygon Table from the popup menu.

Share this post


Link to post
Share on other sites

Hi TX,

if you're using RockWorks 15 open the Polygon Table and from the toolbar select Plot. Continue to produce a RockPlot2D image of your polygon. Next select Utilities|Clip - Based on Coordinates and enter your project coordinates which will create a new RockPlot2D image of your clipped polygon. Select the polygon and right and select Save To Polygon Table from the popup menu.

Share this post


Link to post
Share on other sites

TX Mitch, This technique works & means a manual entering of the project dimensions. I was looking for an automatic clip to the project dimensions, maybe a future RW improvement?

Craig

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×