Jump to content
RockWare Support Forum
Olafsson

Fault location on 2D sections

Recommended Posts

I would like to make a stratigraphic cross section where the localities of faults are marked above the profile. The faults have been traced from a geological map, so that a fault table exists.

In this way I would be able to at least draw the faults myself, knowing exactly where they cut the surface.

How could I go about doing this?

Could you please add this feature to the Software, as this is quite basic stuff in drawing cross-sections.

Thank you very much in advance,

Olafsson

Share this post


Link to post
Share on other sites

Hi Olafsson,

One way to handle the fault is to enter it in the Borehole Manager Location table as if it were a borehole. If you are drawing a profile, you can show an inclined fault by entering inclination and azimuth data in the Orientation table.

Thanks,

Tom B

RockWare Inc

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...