Jump to content
RockWare Support Forum
richW

continued issues with Act2 and scatter data

Recommended Posts

Hi,

I have succeeded in following Tom's recommendations to plot 30 or 40 data points from a .gss file onto an Act2 diagram, but now I'm trying it with a big file- 311 samples. nothing plots and i get the following error message:

The instruction at "0x7c910a19" referenced memory at "0x00000000". The memory could not be "read".

Once again, I can't upload the .gss file because I get the error message, "You aren't permitted to upload this kind of data file."

any insight would be appreciated.

thanks,

Rich

Share this post


Link to post
Share on other sites

Hi, Tom (or whomever),

I converted the .gss file to .txt (tab-delimited) and that will upload. My Act2 commands are as follows:

Act2> diagram Al+++ on Al+++ vs pH

Act2> x 2 9; y -20 0

Act2> go

then in the plot view of Act2, I go to open>scatter data>test and that's when I get the error message.

thanks,

rich

test.txt

Share this post


Link to post
Share on other sites

Hi Rich:

I've just configured .GSS as an allowable attachment file type on the forum. Can you try your upload once again?

If unsuccesful, just email it to me.

Also, be sure to include the Act2 file that you are trying to plot scatter data points on...

Regards,

Tom

Share this post


Link to post
Share on other sites

Rich:

As a follow-up, this appears to be a bug tied to the number of samples in the GSS dataset, as the scatter points plot fine when I reduce the GSS dataset that you provided.

We'll get this address in the next patch, GWB 8.0.10.

Regards,

Tom

Share this post


Link to post
Share on other sites

Hi, Tom,

Thanks, I suspected this might be the case. i was playing around with the data last week and was able to get all the points to plot if I broke the dataset into 4 or 5 smaller pieces. So I was reasonably sure that there wasn't a specific problem with any one of the data points. for now, do you know the limit of points i can have without triggering problems?

Rich

Rich:

As a follow-up, this appears to be a bug tied to the number of samples in the GSS dataset, as the scatter points plot fine when I reduce the GSS dataset that you provided.

We'll get this address in the next patch, GWB 8.0.10.

Regards,

Tom

Share this post


Link to post
Share on other sites

Hi Rich:

No, I haven't figured out what the data limit is on this yet. If I have a few spare minutes, I'll try to bracket this a bit more.

Regards,

Tom

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×