Jump to content
RockWare Support Forum
Rosario

mixing fluids

Recommended Posts

I am trying to mix seawater with a well water in react, how do you go about it?

Hi Rosario:

The key is to use the Pickup command. The following general set of steps works for all fluid mixing models:

  • Load water 1 into the React Basis panel
  • Speciate water 1
  • After React converges, "pick up" the speciated fluid via the Run - Pickup - Reactants option (you can pick up the entire speciated system, or the fluid or mineral components only). This will load water 1 component masses into the Reactants pane after speciation.
  • Load water 2 into the Basis pane
  • To set a mixing fraction, use the reactants times option in the Reactants pane

The above instructions are for titrating water 1 into water 2. If you want to run the reverse mixing model, simply reverse the order.

I hope that helps,

Tom Meuzelaar

RockWare, Inc.

Share this post


Link to post
Share on other sites
Hi Rosario:

The key is to use the Pickup command. The following general set of steps works for all fluid mixing models:

  • Load water 1 into the React Basis panel
  • Speciate water 1
  • After React converges, "pick up" the speciated fluid via the Run - Pickup - Reactants option (you can pick up the entire speciated system, or the fluid or mineral components only). This will load water 1 component masses into the Reactants pane after speciation.
  • Load water 2 into the Basis pane
  • To set a mixing fraction, use the reactants times option in the Reactants pane

The above instructions are for titrating water 1 into water 2. If you want to run the reverse mixing model, simply reverse the order.

I hope that helps,

Tom Meuzelaar

RockWare, Inc.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×