
richW
Members-
Content Count
8 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout richW
-
Rank
Newbie
-
Hi, Tom, Thanks, I suspected this might be the case. i was playing around with the data last week and was able to get all the points to plot if I broke the dataset into 4 or 5 smaller pieces. So I was reasonably sure that there wasn't a specific problem with any one of the data points. for now, do you know the limit of points i can have without triggering problems? Rich
-
ok, here goes. thanks! log_Al_vs_pH.ac2 test.gss
-
Hi, Tom (or whomever), I converted the .gss file to .txt (tab-delimited) and that will upload. My Act2 commands are as follows: Act2> diagram Al+++ on Al+++ vs pH Act2> x 2 9; y -20 0 Act2> go then in the plot view of Act2, I go to open>scatter data>test and that's when I get the error message. thanks, rich test.txt
-
Hi, I have succeeded in following Tom's recommendations to plot 30 or 40 data points from a .gss file onto an Act2 diagram, but now I'm trying it with a big file- 311 samples. nothing plots and i get the following error message: The instruction at "0x7c910a19" referenced memory at "0x00000000". The memory could not be "read". Once again, I can't upload the .gss file because I get the error message, "You aren't permitted to upload this kind of data file." any insight would be appreciated. thanks, Rich
-
thanks, Tom, the text file you sent worked just fine, and I'll play with some variations to see what will work. this was just a simple test file to get the ball rolling. your later suggestion was right on the money- now it works in gss as well. thanks very much for the help! rich
-
Hi, Tom, here's the .gss file, saved as tab-delimited text. when I tried to add the text scatter data to the plot, it didn't work either. thanks, rich wanty test.txt
-
Hi, Tom, sorry, but when I try to upload the .gss file, I get the message, "Error You aren't permitted to upload this kind of file" the file is very simple- 4 rows and 4 columns as in my original post. if you send me your email address i will send it to you that way. thanks for the help, Rich
-
Hello all, I am trying to get my data to plot on an Act2 diagram, without success. I am using the following command script in Act2: Act2> diagram Al+++ on Al+++ vs pH Act2> x 3 8; y -10 0 Act2> go with this data set: Sample ID pH Al+++ log a Al+++ mg/l ug/l 04CO-101 04CO-101 6.5 0.0184 -6.176 04CO-102 04CO-102 6.4 0.01022 -6.431 04CO-103 04CO-103 3.5 18.4 -3.176 04CO-104 04CO-104 7.5 0.01 -6.4 (I couldn't upload the gss file b/c it says I'm not permitted to upload this kind of file). in this case, I used Excel to generate {log a Al+++} and made a column in GSS as a us