A Trick for Modeling Lithologic Unconformities

If you are trying to create a lithology model composed of horizontal beds that have been eroded and then overlain by a layer of soil, fill or even material such as concrete, you’ll often find that the horizontal lithoblending algorithm incorrectly places this upper layer of material below the sediments in some places.

One solution is to use some newer tools in the Lithology menu to create two separate Lithology models that can then be combined.  Here is an explanation of how this works.

Let’s start with the “Soil” layer at the top of the model.  First, it is important to assign a G-value to the Soil Lithology Type that is lower or higher than all the other material types.  In this case, the Soil material has been assigned a G-Value of 2.  All of the other material types have been assigned values between 3 and 8.

In the Lithology modeling tree menu, choose to create a model titled “Lithology Warped”.  Warp the model based on a grid that represents ground surface elevations, and turned off the “Randomize Blending” option to avoid interfingering of the soil and sand below.

While the representation of the sediments is probably not reasonable, I think that the soil layer at the top of the model looks much better in the diagram below than it does in the diagram above.

Next, create a model of just the flat lying sediments (in this example, the model is called “Lithology Sediments.mod”).  When creating this model, turn the Randomize Blending option back on, the warping option OFF, and tell the program to limit the model to just materials with G-Values between 3 and 8.

 As you can see in the diagram below, RockWorks has included everything except for Soil in this model.

Finally, use the Solid à Filter à Replacement Filter tool in the RockWorks Utilities, to insert the Soil in the warped model into the sediments model.

The diagram below displays this final model in a cross-section.

     

2 thoughts on “A Trick for Modeling Lithologic Unconformities

  1. I have a problem. Can any one do me a favor in this regards.
    My problem is this that I am willing to create a 2d strip log. The total depth of log is 100 feet. I want to assign rock-works the scale that it show plot 1 inch per 20 feet. and I want a scale as well. Now if any one understand my problem and willing to help me kindly send me solution. I will be thankful to you forever.

    Best Regards
    SARTAJ ALI

  2. RockWorks offers the ability to set the scale when you print the striplog. Choose the File | Print menu command to display the Print Options dialog box. In the Scaling section of the Print Options dialog box, specify the number of units at the prompt “1 inch = __________ units”.